Checking, removing and installing
1. Remove the suspension arm and check the torque of the support, which should be 0.8–3.5 N·m. Otherwise, replace the support.
2. Raise the front of the car and remove the wheel.
3. Remove the upper suspension arm (see subsection 10.2.6).
4. Remove the cover and remove the retaining ring.
5. Using special equipment, press the support out of the lever (1 – lever, 2 – support).
6. Installation of the support is carried out in reverse order.
7. When assembling, align the mark on the support (1) with the center line of the lever (2).
8. Press the support in using the same tooling.
9. Lubricate the support and fill the boot with general-purpose grease.
The material is based on data from the website MitsubishiMan.ru
10. Lubricate the support groove with sealant such as 3M ART 8663 and secure the cover with a ring.
11. Lubricate the support through the grease gun.
12. Adjust the clearance (see subsection 10.2.1) and wheel alignment angles.