Removal and installation the oil pressure sensor (Mitsubishi L200 4)

Unscrew the sensor using the head and key (1).

When installing the sensor, degrease the contact area (arrow).

Apply 3M ATD #8660 sealant to the sensor threads as shown in the figure.

Caution: When applying the sealant, make sure that it does not get into the sensor oil channel.

Tighten the sensor to a torque of 10±2 Nm.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Lubrication system

Next ▶

Oil, pump, balance mechanism and oil pan

Removal the oil pan
Removal and installation the flange screw for fastening the balance shaft gear
Disassembly and assembly of the oil pump
Replacing the rear bearing of the right balance shaft
Installing the driven and driving gears and balance shaft seal

Similar materials for other Mitsubishi models

➤ Oil pressure and pressure sensor — checking Mitsubishi Colt 4 and 5 (1991-2003)
➤ Checking the oil pressure switch sensor Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Checking the condition of the tires and their inflation… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking the engine oil pressure switch sensor Mitsubishi Outlander 1 (2003-2008)
➤ Oil pressure sensor Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the hydraulic fluid pressure switch sensor Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

Владимир Корнев (24.11.2022 22:33)

В автомобиле была проблема с ручной подкачки топлива, менялся датчик ТНВД на новый , датчик уровня давления был заменён, автомобиль дёргался, глох. (Обороты плавали). После 3500 оборотов авто тянет за жопу. Решение проблемы поменял на старый датчик который ТНВД почистил от жёлтого налёта, разобрал (разборный). Как правильно чистить есть на Авито. Поставив обратно всё стало нормально как и должно быть.))

answer quote