Rear axle of the car Mitsubishi L200 4

Technical characteristics and design description
The rear axle of the L200 series vehicles is an example of a dependent suspension with a solid axle body suspended on elliptical springs. The main transmission is of the...

Rear axle assembly
Rear axle design elements: 1. Brake drum; 2. Brake pads and brake shield; 3. Parking brake cable mounting screw; 4. Handbrake cable; 5. Rear wheel speed sensor (for...

Removal and installation axle shafts
Elements of the rear axle shaft assembly: 1. Brake drum; 2. Brake pads and shield assembly; 3. Handbrake cable mounting bolt; 4. Handbrake cable; 5. Rear wheel speed...

Disassembly and assembly of the axle shaft
Elements of the rear axle shaft design: 1. Thrust ring (replace with a new one during assembly); 2. ABS rotor (for vehicles equipped with ABS system); 3. Lock washer...

Rear axle differential lock device (4WD)
Elements of the rear axle differential lock system: 1. Rear axle differential lock system switch; 2. Electronic control unit for rear axle differential lock; 3. Vacuum...

Rear axle differential housing
Differential housing elements: 1. Rear part of the propeller shaft; 2. Rear axle differential lock switch sensor connector (for vehicles equipped with rear axle...

Disassembling the rear axle differential with locking mechanism
Disassembly is carried out in the order shown in Fig. M2 5.059. Differential design elements (for vehicles equipped with differential lock): 1. Locking bar; 2. Side...

Disassembling the rear axle differential without a locking mechanism
Disassembly is carried out in the order shown in Fig. M2 5.060. Differential design elements (for vehicles not equipped with a differential lock): Locking bar; 2. Side...

Assembly of the rear axle differential without a locking mechanism
Assembly is carried out in the order shown in Fig. M2 5.061. Differential design elements (for vehicles not equipped with a differential lock): 1. Differential housing;...

Assembly of the rear axle differential with a locking mechanism
Assembly is carried out in the order shown in Fig. M2 5.062. Differential design elements (for vehicles equipped with differential lock): 1. Differential housing; 2....

Rear axle differential lock mechanism
Elements of the rear axle differential lock mechanism design: 1. Screw; 2. Differential housing (A); 3. Intermediate differential adjusting ring; 4. Left axle gear; 5....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

Link in different formats to this section

TEXTHTMLBB Code