Differential design elements (for vehicles equipped with differential lock): 1. Locking bar; 2. Side bearing nut; 3. Bolt; 4. Bearing cover; 5. Hose; 6. Air tube assembly (A); 7. Eye bolt; 8. Air tube assembly (B); 9. Gasket (replace with a new one during assembly); 10. Differential lock engagement drive; 11. Pressure plate; 12. Outer race of the differential side bearing; 13. Inner race of the differential side bearing; 14. Driven gear of the main transmission; 15. Differential housing; 16. Self-locking nut (replace with a new one during assembly); 17. Washer; 18. Drive gear assembly; 19. Front adjusting washer of the drive shaft-pinion; (for adjusting the preload of the drive gear); 20. Intermediate adjusting ring of the drive gear; 21. Inner race of the rear bearing of the drive gear; 22. Rear adjusting washer of the drive shaft-pinion (for adjusting the height of the drive pinion); 23. Drive gear; 24. Connecting flange; 25. Oil seal (replace with a new one during assembly); 26. Inner race of the front bearing of the drive gear; 27. Outer race of the front bearing of the drive pinion; 28. Outer race of the rear bearing of the drive pinion; 29. Rear axle differential lock switch sensor; 30. Gasket (replace with a new one during assembly); 31. Differential housing
The article was obtained from this portal: mitsubishiman.ru