Disassembly and assembly of the brake master cylinder (Mitsubishi L200 4)

Disassembly is carried out in the order shown in the figure.

Assembly is carried out in reverse order.

1. Tank lid; 2. Membrane; 3. Pin; 4. Reservoir; 5. Sealing the tank; 6. Brake fluid level indicator switch; 7. Piston holder; 8. Primary piston assembly; 9. Secondary piston assembly; 10. Master cylinder body

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Brake system

Next ▶

Removal and installation the brake booster
The structure of the braking system
Brake system specifications
General description of the braking system
Checking the brake light switch

Removal and Installing the LSPV (Low Voltage Variable Pressure Valve) (without ABS)
Removal and installation front brake discs
Checking the braking force
Disassembling and assembling the front disc brake
Removal and installation the rear drum brake

Similar materials for other Mitsubishi models

➤ Master Brake Cylinder — Disassembly and Assembly Mitsubishi Colt 4 and 5 (1991-2003)
➤ Master cylinder and brake booster Mitsubishi Lancer 9 (2000-2007, petrol)
➤ Removal and installation the master brake cylinder Mitsubishi Galant 6 and 7 (1987-1998)
➤ Disassembly and assembly of the clutch master cylinder Mitsubishi Outlander 1 (2003-2008)
➤ Brake Master Cylinder — Removal and Installation Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Master cylinder and brake booster Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet