Removal and Installing the LSPV (Low Voltage Variable Pressure Valve) (without ABS) (Mitsubishi L200 4)

1. Spring support; 2. Spring holder; 3. Bracket; 4. Pipe connection; 5. LSPV (Low Voltage Variable Pressure Valve); 6. Bracket; 7. Brake system bleed valve

Removal is carried out in the order shown in the figure.

Installation is performed in the reverse order. After installation, it is necessary to fill the brake system with brake fluid and release air, and also check and adjust the length of the mass sensor spring (see the Maintenance chapter).

[The article was taken from the website mitsubishiman]

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Brake system

Next ▶

Disassembly and assembly of the brake master cylinder
Removal and installation the brake booster
The structure of the braking system
Brake system specifications
General description of the braking system

Removal and installation front brake discs
Checking the braking force
Disassembling and assembling the front disc brake
Removal and installation the rear drum brake
Disassembly and assembly of the rear drum brake slave cylinder

Similar materials for other Mitsubishi models