1. Screw; 2. Caliper bracket with lining, clamp and gasket; 3. Pin; 4. Pin cap.; 5. Lining assembly with wear indicator (left wheel only); 6. Overlay assembly; 7. Gasket; 8. Gasket cover; 9. Clamp; 10. Piston cap (see below); 11. Piston (see below); 12. Piston seal (see below); 13. Caliper housing
Disassembly is performed in the order shown in the figure. Assembly is performed in the reverse order.
Article reprinted from the website [MITSUBISHIMAN.ru]
Removal the piston with the cap
To remove the piston with the cap, blow it out with air through the brake hose. Increase the air pressure gradually, otherwise you can damage the piston.
Removal the piston seal
The seal should be removed with a finger (to avoid damaging the cylinder surface, it is not recommended to use metal objects). After removal, clean the inner surface of the cylinder and the piston with alcohol or DOT3 or DOT4 brake fluid.