1. Brake drum - after removing the drum, disconnect the parking brake cable; 2. Brake shoe spring; 3. Clamp; 4. Automatic adjustment lever; 5. Retaining spring; 6. Shoe retaining spring; 7. Pin holding the shoe; 8. Adjustment unit; 9. Piston spring; 10. Block assembly with lining; 11. Brake shoe assembly with lever; 12. Holder (removal and installation see below); 13. Wave washer (see below for installation); 14. Pin; 15. Parking brake lever; 16. Block assembly with lining; 17. Brake pipe; 18. Plug; 19. Brake cylinder assembly; 20. Parking brake cable; 21. Brake shoe support shield
Removal is carried out in the order shown in figures M2 7.042 - M2 7.043.
installation is carried out in reverse order, observing the instructions below. After installation, fill the brake system with brake fluid, release air and adjust the parking brake.
Removal and installation the holder
By turning a flat-head screwdriver between the locking edges, push them apart and remove the holder. When installing, clamp the locking edges with pliers.
Installing a wave washer
Install the wave washer as shown in the illustration.
(The material is based on data from the website: www.MitsubishiMan.ru)