Contents: Removal ⤓ Removal the clamps ⤓
Removal
Remove the rear combination light.
Remove the rear door sill trim.
Remove the vent cover.
Disconnect the rear bumper wiring harness connector.
The parts are removed in the order shown in the figure.
Removal the clamps
Using pliers, squeeze the latches of the holders and then remove the holders from the interior.
Installation of parts is carried out in the reverse order of removal.
After completing the installation of the parts, connect the rear bumper wire harness connector.
Install the vent cover.
Install the rear door sill trim.
Install the rear combination light.
The article is reprinted from a web resource: www.MitsubishiMan.ru