Contents: Removal ⤓ Installation ⤓
Fig. 17.63. Rear bumper: 1 - overlay; 2 - mudguard; 3 - rear bumper
Fig. 17.64. Rear bumper: 1 - side bracket; 2 - bumper reinforcement; 3 - rear bumper
Removal
- Remove the cover.
- Using a special tool, pull the center rods out of the clips, then remove the clips and remove the rear mudguards.
- Remove the screws securing the top, bottom and side parts of the bumper and, pulling back, remove the bumper from the car.
- Remove the screws and side bumper bracket.
Installation
- Installation is carried out in the reverse order of removal.
(The article was obtained from this portal: MitsubishiMan)