Front wing (Mitsubishi Space Star)

Fig. 17.4. Front wing: 1 - side turn signal repeater; 2 - mudguard; 3 - wing

Removal

• Remove the front bumper.
• Remove the headlight from the appropriate side of the vehicle.
• Remove the side fairing from the wing.
• Unscrew the self-tapping bolts, remove the pins and remove the fender liner.
• Remove the side protective molding from the wing.
• Unscrew the bolts around the perimeter of the wing and remove the wing.

Installation

• Clean off any remaining old sealant from the mated surface of the body and apply a thick layer of fresh sealant.
• Install the wing on the car and temporarily secure it with bolts. Adjust the wing position by moving it and finally tighten the bolts.
• Install the side turn signal repeater retainer into the hole in the wing, then press the front part of the turn signal repeater until it is firmly fixed in the wing (Fig. 17.5).

Fig. 17.5. Installing the side turn signal repeater

• Install the mudguard and secure it with bolts and clips.
• Install the headlights.
• Install the side fairing.
• Install the front bumper.