The parts are removed in the order shown in the figure.
Removal rivets
Drill a hole (6.5mm diameter for rivet "A" and 4.0mm diameter for rivet "B") into the rivet and remove it.
The original material is posted on the website www.MitsubishiMan.ru
Installation of parts is carried out in the reverse order of removal.
Installing rivets "A" and "B"
Install rivets using a special tool.
Installing protective film
Make sure that the ambient temperature is between 20–38°C and the surface where the protective film is attached is free of contamination.
If the ambient temperature is less than 20°C, heat the protective film and its installation surface to 20–30°C.
When installing the protective film, make sure that no air bubbles have formed under the film.
Clean (degrease) the places where the protective film will be installed with isopropyl alcohol.
Remove the paper backing and stick the protective film as shown in the picture.