Removal and installation the hazard warning light switch/rear fog light switch (Mitsubishi Lancer 3)

Removal

Remove the corresponding switch from the switch panel using a wide screwdriver. The figure shows the version with 9.88.

If present, disconnect the connection connector from the back of the switch.

Installation

Connect the switch and insert it into the switch panel cutout.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Lancer 3 and 5: Equipment and devices

Next ▶

Removal and installation the ignition switch / steering wheel lock
Removal and installation / disassembly of the turn signal / windshield wiper switch
Removal and installation the instrument panel / Replacing the bulbs
Devices — General information
Removal and installation the rear light

Removal and installation speakers/radio
Removal and installation a pin antenna
Replacing the wiper blade rubber
Removal and installation / adjustment of windshield washer nozzles
Removal and installation the windshield wiper motor

Similar materials for other Mitsubishi models

➤ Hazard warning light switch Mitsubishi Colt 5 (1995-2003, petrol)
➤ Hazard warning light switch Mitsubishi Galant 6 and 7 (1987-1998)
➤ Hazard warning light switch Mitsubishi L200 4 (2005-2014, diesel)
➤ Rear fog light switch Mitsubishi Outlander 1 (2003-2008)
➤ Hazard warning light switch Mitsubishi Pajero 4 (2006-2021)
➤ Hazard warning light switch Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Lancer 9 (2000-2007, petrol)