Home Colt Lancer Galant L200 Outlander Pajero Others

L200 4 (2005-2014, diesel)

Removal and installation the clutch release fork (Mitsubishi L200 4)

0

Contents: Removal ⤓ Installation ⤓

Removal

To remove the fork, pull it out in the direction of the arrow as shown in Fig. M2 4.020.

Installation

Installation is carried out in the reverse order. Before installation, apply consistent grease to the contact surfaces of the fork.

Caution: Be careful when installing the fork: if you press the fork in the wrong direction, the spring clip may be damaged.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

Next ▶

Disassembly and assembly of the clutch mechanism (coupling)
Installing the master cylinder rod
Disassembly and assembly of the clutch master cylinder
Removal and installation the clutch release drive
Clutch specifications

Installing the release bearing
Installing the clutch release mechanism
Clutch slave cylinder disassembly procedure

Similar materials for other Mitsubishi models

➤ Release Bearing, Clutch Release Fork and Fork Axle —… Mitsubishi Colt 2 and 3 (1983-1993)
➤ Checking the clutch fluid level Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal, checking and installation the release bearing and… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking the level of working fluid in the clutch hydraulic… Mitsubishi Outlander 1 (2003-2008)
➤ Clutch release sensor (vehicles with manual transmission) Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the clutch release sensor Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.