Installing the release bearing (Mitsubishi L200 4)

Before installation, apply consistent grease to the areas indicated in Fig. M2 4.021.

Install the heel pad onto the guide.

Install the fork.

Secure the bearing with clamps.

The article is based on data from the website: MitsubishiMan.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Clutch

Next ▶

Removal and installation the clutch release fork
Disassembly and assembly of the clutch mechanism (coupling)
Installing the master cylinder rod
Disassembly and assembly of the clutch master cylinder
Removal and installation the clutch release drive

Installing the clutch release mechanism
Clutch slave cylinder disassembly procedure

Similar materials for other Mitsubishi models

➤ Release bearing — removal and installation Mitsubishi Colt 4 and 5 (1991-2003)
➤ Removal and installation the release bearing Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal, checking and installation the release bearing and… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Removal, Checking and Installing the Oil Pan (2WD Models) Mitsubishi Outlander 1 (2003-2008)
➤ Clutch release cable drive parts Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the clutch release sensor Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet