Contents: Removal the wiring harness connector ⤓ Removal the hydraulic unit assembly ⤓ Installing a brake pipe ⤓
Removal the wiring harness connector
Turn the lock lever in the direction of the arrow as shown in the figure to unlock the lock, then disconnect the connector.
Removal the hydraulic unit assembly
Caution! The hydraulic unit assembly is heavy, so be careful when removing it.
The hydraulic unit assembly is a non-disassemblable structure, therefore it is prohibited to loosen any bolts and nuts.
Do not drop or hit the hydraulic unit.
Do not turn the hydraulic unit over or lay it on its side.
Installing a brake pipe
1. To the rear brake pressure regulator (right wheel)
2. To the rear brake pressure regulator (left wheel)
3. From the main brake cylinder (primary chamber)
4. From the master brake cylinder (secondary chamber)
5. To the front brake mechanism (right wheel)
6. To the front brake mechanism (left wheel)
Connect the hydraulic block pipes as shown in the figure.
The original article is on the website www.MitsubishiMan.ru