The sensor is installed on the fuel filter.
 |  |
Original material on the website (www.MitsubishiMan.ru)
The sensor is installed on the fuel filter.
Original material on the website (www.MitsubishiMan.ru)
Fuel filter pressure sensor (if the vehicle is equipped with one) (Mitsubishi L200 4)
The sensor signal is used to determine the degree of contamination of the fuel filter.
The sensor is installed on the fuel filter.
Original material on the website (www.MitsubishiMan.ru)
The sensor is installed on the fuel filter.
Original material on the website (www.MitsubishiMan.ru)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Nikita Romanov
Share with friends:
Similar materials for other Mitsubishi models
➤ Relieving pressure in the fuel system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Checking the oil pressure switch sensor Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation the fuel pump / fuel flow sensor Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking the engine oil pressure switch sensor Mitsubishi Outlander 1 (2003-2008)
➤ Fuel level and coolant temperature sensor Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Removal water from the fine fuel filter (diesel engines… Mitsubishi Carisma (1995-2004)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Diesel engine
- Lubrication system
- Fuel system
- Control system
- Transmission
- Clutch
- Mechanical gearbox
- Transfer case
- Front axle
- Rear axle
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits