Removal and installation the front passenger airbag (Mitsubishi L200 4)

Removal is carried out in the following order.

Glove box lid.

1. Front passenger airbag module (see below).

Installation is carried out in reverse order, with checks (see below) performed before and after installation (after connecting the battery).

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Brake system

Next ▶

Removal and installation the steering wheel position sensor
Acceleration and Yaw Rate Sensor — Removal and Installation
Safe mode and stability system diagnostic functions
The principle of operation of ASC and ATC systems
Actuators of the stability control system

Removal and installation the driver's airbag and rotating joint

Similar materials for other Mitsubishi models

➤ Front Crankshaft Oil Seal (SOHC, 16 valves) Mitsubishi Colt 4 and 5 (1991-2003)
➤ Steering / Front Wheel Drive Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Front seat adjustment Mitsubishi Galant 6 and 7 (1987-1998)
➤ Front fog light switch Mitsubishi Outlander 1 (2003-2008)
➤ Front seat back assembly (side airbag module) Mitsubishi Pajero 4 (2006-2021)
➤ Front passenger airbag Mitsubishi Space Star (1998-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet