Contents: Removal ⤓ Installation ⤓
Removal
Remove the camshaft drive belt.
Remove the crankshaft V-belt pulley.
Remove the crankshaft gear (1) and key (2).
Remove the sensor rotor and crankshaft bushings (if equipped).
Drill two holes in the front crankshaft oil seal. Screw two self-tapping screws into the drilled holes in the oil seal and, using pliers, pull the oil seal (5) out by the screw heads.
Clean the oil seal seat.
Installation
Installation is carried out in the reverse order, taking into account the slightly blown:
Lubricate the entire working edge of the oil seal with clean engine oil (arrow).
Original source of information: MITSUBISHIMAN.ru
Install the seal (4) by tapping it on the mandrel until it is flush with the seal housing.
1- crankshaft; 2, 3 - mandrel; 4 - oil seal.