2. Stop the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced.
Sedan
Station wagon
Attention:
- Install the jack only in the recommended position. If the jack is installed incorrectly, dents may form in the car body or the jack may fall, injuring you.
- Avoid installing the jack on a slope or unstable surface. Otherwise, the jack may tilt and move from the installation position or fall, which may cause an accident. Always install the jack on a flat, hard surface.
- Before installing the jack, make sure that there is no sand or small stones on the supporting surface.
The original article was published on: MITSUBISHIMAN
3. Turn the jack shaft tip until the slot in the jack stop touches the body flange.
4. Install the hook of the jack lever (standard mount) into the hole on the tip of the jack shaft and install the wheel brace on the jack lever as a lever handle. Turn the jack lever handle to raise the car until the wheel does not touch the ground.
Note: To avoid tipping, only raise the vehicle high enough to remove or change a wheel.
5. After completing the work, lower the vehicle and fold the jack.