- a) During and after engine operation, the exhaust pipe is heated to a high temperature. To avoid fire, do not park the vehicle over flammable materials such as leaves, paper, dry grass, etc.
- b) Use only unleaded gasoline.
- c) Do not drive with a very low fuel level in the tank.
- d) Do not allow the engine to idle for more than 20 minutes.
- d) Do not tow the vehicle.
2. Keep the engine in good working order. Malfunctions in the ignition and power supply system can cause the catalytic converter to overheat.
3. When operating the vehicle, observe the following precautions:
- a) Avoid inhaling engine exhaust gases, this may cause unconsciousness or even death, as the gases contain carbon monoxide (a colourless, odourless gas).
- b) Periodically check the exhaust system for holes or loose fasteners. Check the system immediately if there is any abnormal noise in the exhaust sound or exhaust gases entering the passenger compartment.
- c) Do not allow the engine to run in a closed area (garage) longer than necessary to enter or exit.
- d) Do not remain in a parked vehicle for a long time with the engine running.
Table. Correspondence of tire sizes with wheel disk parameters.
Recommended tires and wheels.
| Tyre type | Disk | Departure, mm | PCD |
| 185/65R14 86S (sedan) | 5.5JJ | 46 | 100 |
| 195/55R15 84V (station wagon) | 6JJ | 46 | 100 |
Approved tires and wheels for installation
| Tyre type | Disk | Departure, mm | PCD |
| 175/70R14 84S (2WD models) | 5.5JJ | 46 | 100 |
| 175/70R14 84H (2WD models) | 5.5JJ | 46 | 100 |
| 185/65R14 86H | 5.5JJ | 46 | 100 |
| 185/65R14 86S | 5.5JJ | 46 | 100 |
The article is based on data from the website: MitsubishiMan
Note: When installing, make sure that the wheels do not catch on any parts of the car.
