Tightening torques for standard fasteners (Mitsubishi L200 4)

The standard fasteners (screws, bolts, nuts) used on the vehicle have metric threads and are galvanized (zinc). The screw (bolt) heads are marked to indicate the nominal tightening torque (if such data is not provided in the detail drawings).

Tightening torques for standard bolts and nuts

Tightening torques for flange bolts and nuts

Note: Screws marked 4T or 7T are reinforced and must be tightened to the torque specified in the instructions or in the figure.

The source of the article is available at (MitsubishiMan)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Diesel engine

Next ▶

Conventional symbols found in the text and figures
Distinctive features of the 4D56 D-DI engine from the 4D56 and 4D56T
General information about diesel engines

Removal and installation of the power unit
Diesel Engine Specifications
Belts and pulleys for auxiliary drive mechanisms
Toothed drive belts — design description
Removal the timing belt

Similar materials for other Mitsubishi models

➤ Tightening torques for elements and parts of 4G1 engines Mitsubishi Colt 5 (1995-2003, petrol)
➤ Tightening forces of threaded connections Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking the vehicle's suspension for damage and loose… Mitsubishi Outlander 1 (2003-2008)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet