Headlight range correction system (Mitsubishi Lancer 9)

1. The direction of the headlight beam is adjusted by rotating the headlight position correction system regulator, located as shown in the figure.



2. Set the switch to the position corresponding to the vehicle load (number of passengers and cargo weight).

Headlight corrector positions:

2WD models:

• "0" - driver or driver and front passenger.
• "1" - driver and all passengers.
• "2" - driver, all passengers and full luggage compartment load.
• "3" - driver and full luggage compartment load.

4WD models:

• "0" - driver or driver and front passenger.
• "2" - driver and all passengers or driver, all passengers and full luggage compartment.
• "4" - driver and full luggage compartment load.

Interior and luggage compartment lighting

Note: To avoid draining the battery, do not leave the interior lights on for long periods of time when the engine is not running.

[Information copied from the website mitsubishiman.ru]

1. The overhead console contains a passenger compartment light, and the ceiling also contains rear seat and local lighting lights, the switches of which can be set to the following positions:

• the middle position, in which the interior lighting comes on when any door of the car is opened and goes out if all doors are closed.
• "OFF" - position in which the interior lighting does not light, even when the door is opened.
• "ON" - position in which the interior lighting is constantly on.

Note:

- On models with the remote central locking system, after the key is removed from the ignition or all doors are closed, the brightness of the interior lights will decrease and turn off within 30 seconds. However, if one of the following conditions is met, the interior lights will turn off immediately:

• a) When turning the ignition key to the "ON" position.
• b) When locking the doors using the interior driver's door lock button or the key transmitter.

- The rear seat illumination lamp comes on when the rear side doors are opened and goes off when they are closed.

2. To turn on the local lighting lamp, press the corresponding switch. This lamp illuminates a small area in the area of the front seats.



3. (Station wagon) To turn on the luggage compartment lighting, move the switch shown in the figure to one of the possible positions:

• "1" - position in which the luggage compartment lighting is constantly on.
• "2" is the middle position, in which the luggage compartment lighting comes on when the rear door is open and goes out when it is closed.
• "3" - position in which the luggage compartment lighting does not light, even when the rear door is opened.