Checking the brake fluid level sensor (Mitsubishi Outlander 1)

The brake fluid level sensor is in good condition if the circuit is open when the float surface is above the "MIN" mark and closed when the float surface is below the "MIN" mark.

(The original material is posted on the website: «MITSUBISHIMAN.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Arseny Pavlov

Share with friends:

◀ Previous

Outlander 1: Brake system

Next ▶

Checking the operation of the rear brake pressure regulator
Checking the operation of the check valve
Checking and adjusting the brake pedal
Checking the brake disc
Checking for leaks in brake system pipes and hoses

Parking brake specifications
Running-in of parking brake linings
Removal and installation the parking brake lever
Removal and installation brake pads and drum mechanism
Removal and installation the brake master cylinder and brake booster

Similar materials for other Mitsubishi models