Inspection of front and rear suspension components (Mitsubishi L200 4)

When inspecting the suspension externally, you should pay attention to the condition of the elements that determine the safety of movement. These are primarily the wheel fastening elements: ball joints, springs, U-shaped rear axle mounting bolts, suspension arms, steering rod ends.

Front suspension: 1. Noise or oil leaks from the shock absorber; 2. Surface damage and spring sagging; 3. Damage to the surface and wear of the stabilizer bushings; 4. Cracks, bends and dents (mechanical damage)

Rear suspension:1. Noise or oil leaks from the shock absorber; 2. Mechanical damage, wear and sagging of springs; 3. Mechanical damage and deformation

The original was published on the website (mitsubishiman.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Maintenance

Next ▶

Removal water from the fuel filter
Removal air from fuel lines
Replacing the fuel filter
Checking the level and density of battery electrolyte
Replacing brake fluid and bleeding air from the hydraulic brake drive

Checking the condition of ball joints and dust boots
Lubrication of cardan shaft crosspieces
Checking the steering
Checking the oil level in the manual transmission and transfer case (4WD)
Changing oil in manual transmission and transfer case (4WD)

Similar materials for other Mitsubishi models