Checking the thickness of the rear drum brake shoes and brake drum (Mitsubishi L200 4)

The location for measuring the thickness of the pads is shown in the figure.

Normal thickness value (A): 5.0 mm.

Minimum permissible thickness of the pads: 1.0 mm.

Measuring the inner diameter of the brake drum

The measurement is taken in at least 2 places.

Normal diameter value: 295 mm.

Maximum allowable value: 297 mm.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Maintenance

Next ▶

Checking brake pads and brake discs for wear
Checking the front and rear wheel hub bearings
Checking tire wear and wheel alignment
Checking and adjusting the travel of the parking brake lever or rod
Checking and adjusting the free travel of the clutch pedal

Checking the condition of fuel lines
Checking the fluid level in the automatic transmission
Automatic transmission fluid replacement
Flushing the automatic transmission fluid cooling lines
Changing engine oil and oil filter

Similar materials for other Mitsubishi models

➤ Rear wheel drum brake shoes — removal and installation Mitsubishi Colt 4 and 5 (1991-2003)
➤ Removal and installation the rear wheel hub/brake drum Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Drum brake shoes — replacement Mitsubishi Galant 5 (1983-1989, petrol)
➤ Disassembling and assembling the rear drum brake Mitsubishi Outlander 1 (2003-2008)
➤ Replacing rear drum brake shoes Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking the thickness of the brake shoe linings of drum… Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet