2. Remove the oil filler cap.
3. Remove the drain plug from the oil pan.
4. After draining the oil, install the drain plug with a new gasket and tighten the plug to 39 Nm.
5. Fill the engine with oil in the amount of 7.4 liters (including the volume of the oil filter and oil cooler). The complex of service properties of the oil: not worse than CF-4 according to the API classification.
6. Install the oil filler cap.
7. Check the engine oil level.
Changing the oil filter for engine oil
1. Start the engine and warm it up to a temperature of 80°C to 90°C.
2. Remove the oil filler cap.
3. Remove the drain plug from the oil pan and drain the oil.
4. Remove the oil filter (1).
5. Clean the surfaces on the oil filter bracket that come into contact with the oil filter.
6. Lubricate the filter sealing ring with a small amount of oil.
7. Fill the filter with fresh oil.
8. Install the filter by tightening it with your hands. The filter is considered to be installed correctly if, after the sealing ring touches the surface of the oil filter bracket, the filter is turned approximately 3/4 of a turn, which corresponds to a tightening torque of approximately 22 Nm.
9. Install the drain plug with a new gasket and tighten the plug to 39 Nm.
10. Fill the engine with fresh oil.
11. Check for oil leaks.