Gearbox — device (Mitsubishi Lancer 3)

The gearbox forms a single unit with the wheel drive. It is removed downwards without the engine. Removal is required if it is necessary to remove the clutch or if the gearbox needs to be repaired. However, since it is in no case recommended to repair the gearbox using household tools, only the removal of units is described here.

1 - Stretching
2 - Gear shift rods
3 - Clutch cable
4 - Slave cylinder
5 - Electrical wire to the reverse light
6 - Tachometer shaft
7 - Starter
8 - Upper mounting bolt
9 - Gearbox bracket

Original source of information (MitsubishiMan.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Lancer 3 and 5: Car gearbox

Next ▶

Removal and installation the gearbox
Gear shift drive — device
Adjusting the gear shift lever
Automatic transmission — general information
Adjusting the Automatic Transmission Throttle Control Cable

Similar materials for other Mitsubishi models