Removal and installation of cardan shafts (Mitsubishi L200 4)

Set the transfer case control lever to the "2H" position.

Drain the oil from the transfer case.

Apply alignment marks.

Sequence of removal of cardan shafts: 1. Self-locking nut; 2. Driveshaft assembly (2WD); 3. Rear propeller shaft assembly (vehicles with Easy select 4WD); 4. Rear propeller shaft assembly (vehicles with Super select 4WD); 5. Spacer sleeve (vehicles with Easy seect4M drive); 6. Front propeller shaft assembly (vehicles with Easy select 4WD); 7. Front propeller shaft assembly (vehicles with Soper select 4WD)

The article was taken from the website MitsubishiMan.ru

Caution: Before tightening the universal joint flange fastening screws, remove any remaining oil or grease from their threads to prevent them from loosening spontaneously.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Nikita Romanov

Share with friends:

◀ Previous

L200 4: Transfer case

Next ▶

2WD/4WD mode switching mechanism
4WD Super select drive system — description and operating principle
Design and operating principle of the 2WD/4WD switching mechanism
4WD Easy select drive system — description and operating principle

Disassembly and assembly of cardan shafts
Easy select transfer case disassembly sequence
Super select transfer case disassembly sequence
Removal the gear shift rod
Adjustments before assembly

Similar materials for other Mitsubishi models