Caution: Use only the recommended brake fluid. Avoid mixing the recommended fluid with other types of brake fluid.
Brake fluid SAE J1703 or FMVSS 116 DOT3 or DOT4
Bleeding the Master Cylinder
Note: There is no check valve in the master brake cylinder. Therefore, if there is no brake fluid in the master brake cylinder, it is recommended to bleed the air from the master brake cylinder before bleeding the air from the brake hydraulic lines.
1. Fill the brake fluid reservoir with brake fluid.
2. Press and hold the brake pedal.
3. Have an assistant place his finger over the outlet of the master cylinder.
4. Without opening the outlet of the master cylinder, release the brake pedal.
5. Repeat steps "2" - "4" three or four times to fill the internal cavities of the master cylinder with brake fluid.
Bleeding air from the brake hydraulic lines
Start the engine and bleed the brake hydraulic lines in the sequence shown in the figure
