[The text of the article was obtained from the website: MitsubishiMan]
[The text of the article was obtained from the website: MitsubishiMan]
Removal the connecting rod caps (Mitsubishi L200 4)
Before removing the connecting rod caps, apply markings (according to the cylinder) to the side surface of the lower connecting rod head.
[The text of the article was obtained from the website: MitsubishiMan]
[The text of the article was obtained from the website: MitsubishiMan]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Nikita Romanov
Share with friends:
Similar materials for other Mitsubishi models
➤ Pistons and connecting rods — removal Mitsubishi Colt 4 and 5 (1991-2003)
➤ Disconnecting and connecting connectors in MITSUBISHI Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Pistons/Connecting Rods — Removal Mitsubishi Galant 5 (1983-1989, petrol)
➤ Socket for connecting additional electrical appliances Mitsubishi Outlander 1 (2003-2008)
➤ Pistons and connecting rods — removal, inspection and… Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Connecting the brake pipes to the pressure regulator Mitsubishi Carisma (1995-2004)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Diesel engine
- Lubrication system
- Fuel system
- Control system
- Transmission
- Clutch
- Mechanical gearbox
- Transfer case
- Front axle
- Rear axle
- Chassis and running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits