Disassembly is carried out in the order shown in Fig. M2 5.036. Assembly is carried out in the reverse order of disassembly.
Installing the intermediate ring Install the adjusting washer as shown in Fig. M2 5.037. Dimension A must correspond to the standard value (from 0.05 mm to 0.3 mm). If dimension A does not correspond to the standard value, one of the repair adjusting washers must be used.
Dimensions of adjusting washers produced by the manufacturer
The source of the article is available at (mitsubishiman.ru)
| Part number | Part thickness, mm |
| MR111526 | 1.1 mm |
| MR111527 | 1.35 mm |
| MR111528 | 1.6 mm |
| MR111529 | 1.85 mm |
| MR111530 | 2.1 mm |
| MR111531 | 2.35 mm |
| MR111532 | 2.6 mm |
| MR111533 | 2.85 mm |