1. Front flange of the propeller shaft; 2. Self-locking nut (replace with a new one during assembly); 3. Bolt for fastening the rear crossmember of the front suspension; 4. Rear crossmember of the front suspension, complete; 5. Vacuum hoses; 6. Differential bracket mounting bolt; 7. Inner shaft housing, front differential housing and differential mounting bracket; 8. Right differential mounting bracket; 9. Left differential mounting bracket; 10. Pin; 11. Connecting sleeve; 12. Drive boot; 13. Vacuum tube; 15. Inner shaft housing; 15a. Inner shaft housing (view from differential side); 16. Breather tube; 17. Front differential housing assembly
Disassembly is carried out in the order shown in Fig. M2 5.033. Assembly is carried out in the reverse order of disassembly.
Removal and installation the propeller shaft
Before removing the propeller shaft, make marks on the propeller shaft flange and the differential housing (see Fig. M2 5.034). This will allow you to install the propeller shaft in the position it was in before removal.
Installing vacuum hoses
Vacuum hoses are installed as shown in Fig. M2 5.035.
