Projection method
1. Perform measurement when the measurement area is projected onto the plate.
2. The difference in height of the measured points must be taken into account when measuring.
3. Height refers to the distance from the standard line (100mm) to the lower measurement point.
Actual measurement method
1. Measure the actual distance between the measurement points.
2. Use a tape measure or distance gauge to measure.
Note: Make sure that distance A is equal to distance A'.
3. Insert the probe of the measuring device into the hole to be measured.
4. When using a mark to take measurements, set the measurement point at the center of the mark.
5. When measuring the suspension arm mounting position or the tie rod installation position, use the mounting bolt (only type B).
6. The measuring point shown in the figure is symmetrical for the left and right sides of the vehicle.
