Removal the license plate cover
1. Remove the right and left lower trim of the luggage compartment door (1).
2. Disconnect the rear fog light connector connection (2).
3. Remove the rear fog light (3).
4. Remove the angle sensor (4).
5. Remove the license plate cover (5).
6. Remove the luggage compartment door trim.
7. Remove the right and left luggage compartment door trim (6).
Installing a license plate cover
Note: When installing, tighten the bolts to the tightening torques shown in the figure.
1. Install the right and left luggage compartment door trim (6).
2. Install the luggage compartment door trim.
The source of the article is available at mitsubishiman
3. Install the license plate cover (5).
4. Install the angle sensor (4).
5. Install the rear fog light (3).
6. Connect the rear fog light connector (2).
7. Install the right and left lower trim of the luggage compartment door (1).