Home Colt Lancer Galant L200 Outlander Pajero Others

Lancer 9 (2000-2007, petrol) Lancer 3 and 5 (1984-1992)

Checking the rubber seals of the drive shafts (Mitsubishi Lancer 3)

0

Raise the car.
Inspect the rubber of the cuffs for porosity and damage while carrying them. Replace torn protective cuffs of the hinges immediately.
Immediately replace the cuffs pulled into the hinge.

Pay attention to traces of oil on the cuff and nearby.
Check the reliability of the fastening of the tie clamps.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Lancer 3 and 5: Maintenance

Next ▶

Differential Gearbox: Checking Oil Level
Automatic Transmission: Oil Change
Automatic Transmission: Checking the Oil Level
Gearbox: Oil change
Gearbox: Checking the oil level

Differential Gearbox: Oil Change
Checking the clutch fluid level
Brakes / Wheels / Tires
Checking the brake fluid level
Checking the thickness of brake pads

Similar materials for other Mitsubishi models

➤ Checking the rubber seals of the drive shafts Mitsubishi Colt 4 and 5 (1991-2003)
➤ Checking the condition of the protective covers of the… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Checking and adjusting the tension of auxiliary drive belts Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the level of working fluid in the clutch hydraulic… Mitsubishi Outlander 1 (2003-2008)
➤ Drive Belts — Checking and Adjusting Tension Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Checking and adjusting the tension of the generator drive… Mitsubishi Carisma (1995-2004)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Lancer 9 (2000-2007, petrol)

This resource sets cookies 🍪 to avoid bothering you with repeated data entry.