Servo pump V-belt (all engines) (Mitsubishi Lancer 3)

Loosen the servo pump mounting and clamping bolts and press the pump against the engine. This will loosen the V-belt, see also Fig. K-1006 in the section "Removing and installing the engine".

Remove the V-belt.

Place the V-belt on the pulleys.

Press the servo pump away from the engine and thus slightly tighten the belt. Check the correct fit of the V-belt on the pulleys and then adjust the tension. The required value is 6.0 + 9.0 mm.

Tighten the clamping and mounting bolts to 50 Nm.

Check the belt tension again and repeat the adjustment if necessary.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Dmitry Vasiliev

Share with friends:

◀ Previous

Lancer 3 and 5: Engine repair

Next ▶

V-belt alternator — diesel engine
Alternator V-Belt — Gasoline Engine
Compression Test — All Engines
Checking the valve clearance compensator of a diesel engine
Checking/Adjusting Valve Clearances — All Engines

Air conditioning compressor V-belt (all engines)
Checking V-Belt Tension — All Engines
Engine fault diagnostics

Similar materials for other Mitsubishi models