The sensor is fixed to the steering gearbox. When the power steering is operating, the sensor sends a signal to the engine control unit, according to which the engine is rebuilt via the idle speed controller to an increased load.
Disconnect the sensor connector. Connect a voltmeter to the contact and ground (e.g. engine block). Turn on the ignition, the required value: 11-13 V. Turn off the ignition. Otherwise, find and eliminate the break according to the electrical diagram.
The text of the article was taken from the website mitsubishiman.ru
Power Steering Pressure Switch Sensor — Check (Mitsubishi Lancer 3)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Dmitry Vasiliev
Share with friends:
Similar materials for other Mitsubishi models
➤ Checking the fluid level in the power steering system Mitsubishi Colt 4 and 5 (1991-2003)
➤ Removal and installation the reverse light switch sensor Mitsubishi Galant 6 and 7 (1987-1998)
➤ Steering column turn signal switch Mitsubishi L200 4 (2005-2014, diesel)
➤ Checking the power steering pressure switch sensor Mitsubishi Outlander 1 (2003-2008)
➤ Checking the power steering hydraulic fluid pressure switch Mitsubishi Pajero 4 (2006-2021)
➤ Checking the hydraulic power steering fluid pressure sensor Mitsubishi Space Star (1998-2005)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Repair of MPI engines
- Repair of GDI engines
- Engine overhaul
- Cooling and lubrication system
- MPI fuel injection system
- GDI fuel injection system
- Intake and exhaust system
- Starting and charging system
- Transmission
- Automatic gearbox
- Variator (CVT)
- Drive shafts and gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Doors, locks and windows
- Exterior (external elements)
- Interior (internal elements)
- Electrical equipment
- Heater and air conditioner
- Security system SRS
- Equipment and devices
- Wiring diagrams (saloon)
- Wiring diagrams (wagon)
- General information
- Maintenance
- Power unit
- Engine repair
- Lubrication system
- Cooling system
- Ignition system
- Fuel system
- Carburetor
- Fuel injection
- Diesel power system
- Exhaust system
- Transmission
- Clutch
- Car gearbox
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Wheels and tires
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Heating system
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits