Transfer Case Oil Change (4WD Models) (Mitsubishi Lancer 9)

1. Loosen the drain plug on the transfer case and drain the oil.

2. Tighten the drain plug to the specified torque.

Tightening torque: 30 - 34 Nm

3. Fill with new oil up to the level of the lower edge of the filler hole (filler plug hole).

Recommended transmission oil - DiaQueen Super Hypoid Gear Oil

Oil viscosity no SAE— 75W-90 or 75W-85W

Oil quality according to API - GL-5

Filling capacity - 0.4 l

4. Tighten the filler plug to the specified torque.

The article is reprinted from a web resource mitsubishiman

Tightening torque: 30-34 N·m

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Arseny Pavlov

Share with friends:

◀ Previous

Lancer 9: Maintenance

Next ▶

Checking the Transfer Case Oil Level (4WD Models)
Checking the fluid level in the power steering reservoir
Checking the brake fluid level
Checking the condition of the timing belt
Checking and adjusting drive belts of attachments

Checking the condition and level of the working fluid in the variator or automatic transmission
Replacing the working fluid in a variator or automatic transmission
Cleaning the CVT or automatic transmission fluid cooler lines
Checking the oil level in the rear differential housing (4WD models)
Changing the oil in the rear differential housing (4WD models)

Similar materials for other Mitsubishi models