Bends of hoses and pipes of the main line at small angles are not allowed. The bending radius must be at least 10 times the hose diameter. The hoses must be located at least 80 mm from the exhaust manifold. It is recommended to check the condition of the hoses at least once a year. During repairs (after a line leak in a car service) the hoses must be plugged, and dirt must not be allowed to get inside the tubes.
The article is based on data from the website: www.mitsubishiman.ru
Air Conditioner Line — General Information (Mitsubishi Pajero 1)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article was reviewed by: Arseny Pavlov
Share with friends:
Similar materials for other Mitsubishi models
➤ Checking the air conditioner drive Mitsubishi Colt 4 and 5 (1991-2003)
➤ Current circuit of the air conditioner Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation the heater and air conditioner… Mitsubishi Galant 6 and 7 (1987-1998)
➤ Bleeding air from the brake line Mitsubishi L200 4 (2005-2014, diesel)
➤ Manual air conditioner Mitsubishi Outlander 1 (2003-2008)
➤ Heater and air conditioner Mitsubishi Carisma (1995-2004)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Troubleshooting
- Maintenance
- Technical specifications
- Power unit
- Engine repair
- Cooling system
- Lubrication system
- Fuel system
- Engine management system
- Intake and exhaust system
- Engine electrical equipment
- Transmission
- Clutch
- Manual gearbox
- Automatic gearbox
- Drive shafts
- Chassis and running gear
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Body dimensions
- Electrical equipment
- Safety system (SRS)
- Air conditioner
- Equipment and devices
- Electrical diagrams
- General information
- User manual
- Seats and seat belts
- Instruments and controls
- Driving and operation
- Maintenance
- Power unit
- Gasoline engines
- Diesel engines
- Ignition system
- Engine electrical equipment
- Cooling and lubrication system
- Power and exhaust system
- Fuel system (gasoline)
- Fuel system (diesel)
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and axles
- Chassis and running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Heater and air conditioner
- Cruise control
- Headlights and lighting
- Electrical circuits