Installing the ignition switch (Mitsubishi Pajero 4)

Note: When installing, tighten the bolts to the tightening torques shown in the figure.

1. Install the steering column lock cylinder (5).

2. Install the immobilizer electronic control unit (4).

3. Install the ignition key ring antenna (3).

4. Install the ignition key reminder sensor in the lock (2).

5. Install the ignition switch (1).

6. Install the steering column combination switch.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article was reviewed by: Miroslav Rakov

Share with friends:

◀ Previous

Pajero 4: Equipment and devices

Next ▶

Removal the ignition switch
Setting the signal
Removal the signal
Signal — Failure Diagnostic Table
Installation of the ETACS electronic control unit

Rear window heating device
Immobilizer system — identification code registration method
Immobilizer control module
Remote control for closing/opening doors
Audio and navigation system

Similar materials for other Mitsubishi models