Removal and installation
− The parts are removed in the order of the numbers indicated in the figure "Removing the side door".
Removal the side door. 1 - buffer, 2 - side door wiring harness connector, 3 - side door opening limiter, 4 - side door assembly, 5 - side door upper hinge, 6 - side door lower hinge, 7 - side door lock retainer, 8 - retainer gasket, 9 - side door limit switch cover, 10 - side door limit switch.
− Installation of parts is carried out in the reverse order of removal.
- When installing the parts, pay attention to the operation of installing the door lock retainer.
The material is based on data from the website (MitsubishiMan)
Install the door lock retainer so that the deviation of its center line relative to the center line of the door lock counterpart does not exceed 1.5 mm.
- After completing the installation of the parts, adjust the door.
Checking the side door limit switch 1. Check that the circuit is closed between terminals "1"-"2"-"3" of the connector when the switch button is released (ON).
2. Check that the circuit is open between all connector terminals when the switch button is pressed (OFF).
