Auxiliary instrument and equipment panels, floor sections (Mitsubishi Pajero 1)

1. To remove these panels, you must first remove the equipment installed on these panels (clock, receiver, etc.).

2. To remove the floor section, you need to unscrew the manual transmission lever handle.

3. There is no need to remove the automatic transmission selector handle – it goes through the hole in the panel.

4. To remove the panel, you need to remove the plugs and unscrew the screws, most of which are located next to the ashtray and tray.

5. To unscrew the side mounting screws, it is recommended to remove the front seats.

6. The rear panels and some of the front floor panels have slots for seat belts. When removing the panel, pass the belts through these slots without disassembling the belt fastenings to the body.

7. When removing the panel, disconnect all wires, marking them first.

8. When installing panels and sections, you must first accurately install them in place, tighten the screws 1–2 turns and tighten.

(Article reprinted from the website: MitsubishiMan)