Scrapers must be replaced if glass cleaning is not satisfactory. For convenience, move the brushes to a vertical position by turning the cleaner on and off.
Replacement
1. Lift the brush holder.
2. Press the handle in the center of the holder and remove the brush from the lever.
3. Bend back the brackets and remove the brush ends from the holder.
4. Install the new scraper, making sure it is securely fastened.
Trico model
5. Trico model brushes have a button that, when pressed, releases the brush from the holder.
6. Some of these brushes are removed by pressing on the back of the scraper frame in its widened part.
Anco Model
7. In Anco model brushes, to remove the scraper, unscrew the special brackets on each side of the brush holder, then pull the scraper out in the longitudinal direction.
8. When installing the bracket, click it into place.
Polycarbonate model
9. To remove the Polycarbonate type brush, press the lever which will push the brush out.
10. When installed, the brush is fixed automatically.
Model Tridon
11. To remove the Tridon type brush, place it on a flat, hard surface and pull the end of the scraper counter-clockwise to remove the tab on the scraper from the recess in the plastic backing.
12. Similarly, detach the scraper from the holder at the remaining attachment points.
13. The length of the brushes is cast on the end of the scraper and must correspond to the length of the brush being replaced.
(The source of the article is available at: «www.mitsubishiman.ru»)