Removal the electronic stability control unit
1. Remove the center bottom panel.
2. Disconnect the brake booster buzzer connector (1).
3. Remove the brake booster buzzer (2).
4. Disconnect the ground connector (3).
5. Disconnect the connector to the electronic stability control unit (4).
6. Remove the electronic stability control unit (5).
Installing the Electronic Stability Control Unit
Note: When installing, tighten the bolts to the torques shown in the figure.
1. Install the electronic stability control unit (5).
2. Connect the connector to the electronic stability control unit (4).
3. Connect the ground connector (3).
4. Install the brake booster buzzer (2).
5. Connect the brake booster buzzer connector (1).
6. Install the center bottom panel.