Using headlight beam adjustment equipment
1. Headlamps must be adjusted on proper equipment in accordance with the equipment manufacturer's instructions.
Note: If there are regulations regarding headlight adjustment in the area where the vehicle is used, adjust according to those regulations.
2. Turn the adjusting screws alternately to adjust the headlight beam.
3. When the engine speed is 2000 rpm, adjust the headlights.
Using the screen
1. Bring the tire pressure to the nominal value and leave only one driver in the car, or put a 75 kg load in his place.
2. Set the distance between the screen and the central marks of the headlights as shown in the figure.
3. Check whether the light reaching the screen corresponds to the nominal value.
Nominal value:
- Vertical distance: 36 mm below horizontal (H)
- Horizontal distance: The position at which a 15° inclined beam line intersects the vertical line (V).
(The original article is on the website: «MitsubishiMan.ru»)
Nominal value:
- (Vertical direction) 26 mm below horizontal (H)
- (Horizontal direction) Parallel to the direction of vehicle movement
Caution: When adjusting the headlight beam, cover the headlights that you are not adjusting at the moment. If the outside light makes it difficult to determine the light/dark dividing line, use a curtain, screen or similar material to reduce the influence of outside light.
4. Turn the adjusting screws alternately to adjust the headlight beam.
Caution: Tighten the adjusting screw in the tightening direction.
