Installing a seat belt with pretensioner (Mitsubishi Pajero 4)

1. Install the seat belt with pretensioner (6).

2. Install the lower center pillar trim (5).

3. Tighten the bolt (4).

4. Tighten the screw securing the upper part of the inertial locking mechanism (to turn the safety mechanism on and off) (3).

5. Install the guide cover (2).

6. Raise the limiter and then place the bracket and the inertia locking mechanism plate together so that the protrusion of the limiter fits into the hole in the inertia locking mechanism bracket.

[The material was created based on the website www.mitsubishiman.ru]

7. Screw the inertia locking mechanism bracket and plate together using the screw that secures the upper part of the inertia locking mechanism.

8. Make sure the belt can be pulled out smoothly. If the belt cannot be pulled out smoothly, it is possible that the safety mechanism has not disengaged, so unscrew the screw securing the upper part of the inertia locking mechanism and repeat the installation procedure.