Basic data for adjustments and control
Front axle
| Parameters | Nominal value | Maximum permissible value | |
| Axial clearance in the front wheel hub bearing, mm | - | 0,0 | |
| Moment of resistance at the start of rotation of the front wheel hub bearing, N·m | Short wheelbase | 3.0 or less | |
| Long wheelbase | 3.5 or less | ||
| Setting the length of the protective cover of a twin CV joint, mm | Left hand drive model | 93±5 | - |
| Right hand drive model | 85±5 | - | |
| Special tool opening size (MB991561), mm | When putting on the small clamp of the protective cover of the CV joint with the divider "EUJ" | 2,9 | - |
| When putting on a large clamp of the protective cover of the CV joint with the divider "EUJ" | 3,2 | - | |
| Width of the compressed part of the clamp of the protective cover of the CV joint with the divider "EUJ", mm | 2,4-2,8 | - | |
| Solenoid valve resistance, Ohm | 36-46 | - | |
[The material was borrowed from the website: www.MitsubishiMan.ru]
Rear axle
| Parameters | Nominal value | Maximum permissible value |
| Axial clearance in the front wheel hub bearing, mm | - | 0,0 |
| Moment of resistance at the start of rotation of the front wheel hub bearing, N·m | 3.0 or less | |
| Setting the length of the protective cover of a twin CV joint, mm | 97±3 | - |
| Differential lock system air pump pressure, kPa | 24.5 -39 (-30 - 0°C), 24.5-34 (0- 100°C) | - |
| Pinion clearance, mm | 0.13-0.18 | - |
| Side gear clearance, mm | 0.01 -0.250 | - |