Contents: Removal ⤓ Installation ⤓
G-sensor installation details for 1993-up Galant all-wheel drive models.
Front G-sensor: 1 - Electrical wiring connector; 2 - Front acceleration sensor; 3 - Sensor support bracket
Rear G-sensor: 4 - Pin Electrical Wiring Connector; 5 - G-sensor cover; 6 - Rear acceleration sensor; 7 - Sensor support bracket
G-sensors are used only on all-wheel drive (AWD) models and are installed in the luggage compartment under the carpet (rear sensor) and under the center console assembly in the vehicle interior (front sensor). The sensors transmit information to the ABS ECU about overloads that occur during acceleration or braking of the vehicle. Analysis of incoming signals together with data received from wheel sensors and information about the operating parameters of the power unit allows the ECU to determine the reliability of the traction of the wheel treads with the road surface and control the operation of the hydraulic modulator taking this factor into account.
Removal
1. Remove the center console (front sensor)/trunk carpet (rear sensor) assembly.
2. Disconnect the electrical wiring from the sensor.
3. Remove the cover from the sensor (rear sensor).
4. Remove the sensor from the support bracket. If necessary, also remove the bracket.
Installation
1. If removed, reinstall the sensor support bracket.
The article is based on data from the website: www.mitsubishiman.ru
2. Install the sensor on the bracket and connect the electrical wiring to it. Tighten the mounting bolts to the required torque (11 N·m).
3. Install the sensor cover (rear sensor).
4. Reinstall the console assembly/carpet in the cargo area.