Removing
1. Disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
2. Remove the instrument cluster (see Section Removal and installation of a combination of devices).
3. Turn out fixing screws and remove from assembly a combination cover with protective glasses.
4. Turn out fixing screws and remove the measuring instrument/control lamp requiring replacement.
Installation
1. Install the replacement meter/test lamp on the printed circuit board in the instrument cluster. Screw in and tighten the fixing screws.
2. Replace the glass cover.
3. Set the combination (see Section Removal and installation of a combination of devices).
4. Finally, connect the negative cable to the battery and check that all gauges on the instrument panel are working properly.